FLAT LIGHTBOX

Ultra-flat. Made to measure. Fully controllable.

The ultra-flat tension fabric frame for walls and ceilings - just 60 mm deep, made to your exact dimensions, and installable by one person. Designed for spaces where light should make an impact without the technology being noticeable: shopfitting, retail, showrooms, hospitality, reception areas, and interior design.

The PIXLIP FLAT LIGHTBOX is backlit from behind instead of being illuminated from the edges. This is precisely what makes its ultra-flat design possible: edge-lit systems require more depth as their size increases to create an even surface - the FLAT remains 60 mm deep even in large formats and delivers a homogeneous illuminated surface without hotspots or shadows. With 6,500 Kelvin daylight white, it is the brightest system in the PIXLIP range and therefore not just an advertising surface, but also a light source for the room.

The mounting system is designed for everyday commercial use. All mounting points are prepared with a 3M adhesive pad and calculated in sufficient numbers for the frame to hold on them alone - even in large formats and even when installed by one person. The panel can then be removed again, while the mounting points remain stuck to the wall as drilling guides. A narrow gap remains between the frame and the wall, allowing the power cable to exit on either side. On request, the profiles can be made with 45° angles - two lightboxes then create a 90° corner that can be used to clad room corners and pillars with continuous printed graphics.

The dimmer is installed at the factory. Control is via smartphone using the Tuya app, a wireless remote control, or the FLAT wall switch, which can be mounted without tools using adhesive strips and operated by touch. Up to four zones can be used to group any number of illuminated frames and switch them together. The system is compatible with standard smart home solutions: schedules, dimming sequences, connection to motion sensors - and control from anywhere.

You are free to choose the height and length; each lightbox is made as a custom-made product in Germany from aluminium profiles with an aluminium Dibond back panel. It is delivered fully assembled; only very large formats are split and joined together in a few steps - after installation, the division is no longer visible. The textile print is secured with a continuous rubber keder and can be replaced with a new design in just a few minutes using the pull-tab flag: a new campaign, a new season, a new impression of the space - with the same hardware.